meta data for this page
  •  

Search

You can find the results of your search below.

Matching pagenames:

Fulltext results:

Linear motor coding @nl_bcj_linear_stage
8 Hits, Last modified:
o.jpg?nolink&384x217|mel12_photo.jpg}}| |Carriage-type|S1|S2|P3| ::: | |Carraige-length [mm]|220|300|380... e:mel10.jpg?nolink&408x239|mel10.jpg}}| |Carriage-type|S1|P2|P3| ::: | |Carraige-length [mm]|160|240|320... e:mel14.jpg?nolink&383x222|mel14.jpg}}| |Carriage-type|S1|S2|P3|P4| ::: | |Carraige-length [mm]|160|240|... e:mel17.jpg?nolink&390x253|mel17.jpg}}| |Carriage-type|S1|S2|P3|P4| ::: | |Carraige-length [mm]|160|240|
Can Open standard and extended PDOs @integrated_drive_motors
5 Hits, Last modified:
do_mapping_default.jpg}} |**Index** |**Name** |**Type** |**Register Address** |**Value** | |1|PositionA... do_mapping_default.jpg}} |**Index** |**Name** |**Type** |**Register Address** |**Value** | |1|Interpola... ont> ** |** <font 10pt/inherit;;black;;inherit>Type</font> ** |** <font 10pt/inherit;;black;;inher... nge</font> | **Alarm Register Bits** |**Alarm type** |**D0** |**D1** |**D2** |**D3** |**D4** |**D5**
Input / Output Signals @integrated_drive_motors
5 Hits, Last modified:
} ===== Output Signals ===== ==== PNP - Default type (Default type) ==== The digital output signals are by default PNP type (without internal pull-down).\\ The absolute curr... erit>**FOR CORRECT OPERATION TO AVOID DAMAGED USE TYPE 2, EN 61131-2 Input characteristic curve on PLC I
Integrated Encoder @green_drive_iso
4 Hits, Last modified:
S 1Vpp encoder. The signal output is differential type with a refernce of 2.5V. The signal period corres... olink&150x56}} The signal output is differential type A+/A- and B+, B- TTL 5V. BiSS-C interface is used... orresponds to a pole pitch of 60mm). This encoder type is used in combination with the servo drive that ... igital encoder feedback instead of analog SIN/COS type. {{:green_drive_iso:incremental.jpg?nolink&450x3
Type codes @green_drive_iso
4 Hits, Last modified:
===== Type codes ===== The linear motor can be orderd using one code only which includes the stator siz... pdmdl=2627&refresh=62a6e4f34bd731655104755|Single_Type_Code]]| |Ordering code - Stator part only|[[https... pdmdl=2629&refresh=62a6e4f351caf1655104755|Stator_Type_Code]]| |Ordering code - Slider part only|[[https... t/download/order-codes-rod-shaft-part/?wpdmdl=2631&refresh=62a6e4f358e5a1655104755|Slider_Type_Code]]|
Integrated Encoder @green_drive_motors
4 Hits, Last modified:
S 1Vpp encoder. The signal output is differential type with a refernce of 2.5V. The signal period corres... olink&150x56}} The signal output is differential type A+/A- and B+,B- TTL 5V. BiSS-C interface is used ... rrespond to the pole pitch of 60mm). This encoder type is used in combination with the servo drive that ... igital encoder feedback instead of analog SIN/COS type. {{:green_drive_iso:incremental.jpg?nolink&450x3
Type codes @green_drive_motors
4 Hits, Last modified:
===== Type codes ===== The linear motor can be order using one code only that comprising the stator siz... pdmdl=2627&refresh=62a6e4f34bd731655104755|Single_Type_Code]]| |Ordering code - Stator part only|[[https... pdmdl=2629&refresh=62a6e4f351caf1655104755|Stator_Type_Code]]| |Ordering code - Slider part only|[[https... t/download/order-codes-rod-shaft-part/?wpdmdl=2631&refresh=62a6e4f358e5a1655104755|Slider_Type_Code]]|
Can Open standard SDOs @integrated_drive_motors
4 Hits, Last modified:
Area or signle parameter** | |0x1000|4096|Device type| |0x1001|4097|Error register| |0x1002|4098|Alarm ... e list below| **Alarm Register Bits** |**Alarm type** |**D0** |**D1** |**D2** |**D3** |**D4** |**D5**... <font 11pt/inherit;;black;;inherit>Motion profile type</font> |Read and write | | <font 11pt/inherit;... <font 11pt/inherit;;black;;inherit>Torque profile type</font> |Read only | | <font 11pt/inherit;;blac
Type codes @integrated_drive_motors
4 Hits, Last modified:
===== Type codes ===== The linear motor can be order using one code only that comprising the stator siz... pdmdl=2627&refresh=62a6e4f34bd731655104755|Single_Type_Code]]| |Ordering code - Stator part only|[[https... pdmdl=2629&refresh=62a6e4f351caf1655104755|Stator_Type_Code]]| |Ordering code - Slider part only|[[https... t/download/order-codes-rod-shaft-part/?wpdmdl=2631&refresh=62a6e4f358e5a1655104755|Slider_Type_Code]]|
Cable coding system @mbm_motors
4 Hits, Last modified:
code** |**Option** |**Cable length** |**Connector type on motor side** |**Type of cable** | |DE20000771-5M| |5 meters|M23|flying-leads| |DE20000810-5M| |5 met... code** |**Option** |**Cable length** |**Connector type on motor side** |**Type of cable** | |DE20000962-5M|BISS-C encoder|5 meters|M23|flying-leads| |DE200009
NiLAB Starter Software @nilab_starter
4 Hits, Last modified:
er scale on Parameter window \\ - Corrected Motor type list ## [2.4.2.8] - 02.12.2025 \\ - Renewed scop... Amps \\ - Added check on the pole pitch and Motor type values \\ - Move commutation Offset Degrees value... ws visualization of gauge in respect to the motor type \\ - Change character in surveillance buttons ##... veillance window ## Bug fixes - Corrected motor type detection ## [2.3.1.1] - 01.04.2023 - Added sel
Ordering code @ulco
4 Hits, Last modified:
====== Ordering code ====== |**Type** |**Model** |**Size** | |**Number o f carriages** |**Carriage length** |**Ltot** |**Reduce Position** |**Reducer type** |**Reducer position** |**End flange type** | |ULC|O - Orizontal / V - Vertical|44 / 66 / 88 / 132|N|1... ?direct&636x342|positions.jpg}} ===== End flange type ===== |**Fc - Closed flange** |**Ff - Flange wit
Codesys / TwinCAT Integration @gtw_ethercat
3 Hits, Last modified:
be mapped at the same time. |**Address** |**Data Type** |**Description** | |0x6000|UINT16|Status| |0x60... Output Data Structure ===== |**Address** |**Data Type** |**Description** | |0x7000|UINT16|GTW_CONTROL_W... DO Configuration data ===== |**Address** |**Data Type** |**Description** | |0x8000|Rercord|Gateway conf
HSB (Hall sensor Box) linear positioning system @ironcore_motors
3 Hits, Last modified:
re_motors:hsb.jpg?nolink&500x373|hsb.jpg}} ===== Type code ===== {{:ironcore_motors:hsb_1.jpg?nolink&5... tput signal ===== The HSB standard signal output type is SIN/COS 1Vpp, with a signal period correspondi... re (32mm).\\ The signal output is of differential type with an amplitude of 0.5V per channels and a refe
Connectors Pinout @lma_actuator
3 Hits, Last modified:
====== Connectors Pinout ====== ==== Connector type ==== ==== Speedtec 2 x M23 (power) and M17 (signal... |2|-| ::: | | | |1|SHIELD| ::: | | | ==== Signal type ==== {{:lma_actuator:sin_sign.jpg?nolink&407x234... ve inside the drive please use DN44082 thermistor type curve, with 1800 Ohm of thermistor reset threshol
Nidec M700 Servo Drive @lma_actuator
3 Hits, Last modified:
General Motor Configuration @mbd_servo_drive
3 Hits, Last modified:
MBM Connectors on motor side @mbm_motors
3 Hits, Last modified:
WEBSMART Motor sizing
2 Hits, Last modified:
Error messages @epulse50_dc_servodrive
2 Hits, Last modified:
Main technical data @epulse50_dc_servodrive
2 Hits, Last modified:
Servo Drive Compatilibity @green_drive_iso
2 Hits, Last modified:
Cable coding system @green_drive_motors
2 Hits, Last modified:
Pacdrive3 - Lxm62 servo drive @green_drive_motors
2 Hits, Last modified:
Servo Drive Compatilibity @green_drive_motors
2 Hits, Last modified:
MODBUS RTU debug mode @integrated_drive_motors
2 Hits, Last modified:
NLi integrated linear motors @integrated_drive_motors
2 Hits, Last modified:
uPLC Registers @integrated_drive_motors
2 Hits, Last modified:
Linear guiding system @ironcore_motors
2 Hits, Last modified:
Type code @ironcore_motors
2 Hits, Last modified:
Drive with analog reference @mbd_servo_drive
2 Hits, Last modified:
Fault and Warning Messages @mbd_servo_drive
2 Hits, Last modified:
Ordering code @nl_bcj_linear_stage
2 Hits, Last modified:
Wire connection @nl_eb15_safety
2 Hits, Last modified:
Technical Parameter @nl_eb15_safety
2 Hits, Last modified:
Hiperface communication @reverso_encoder
2 Hits, Last modified:
Service Bulletin - Integrated Drive miniature linear motors @service_bulletin
2 Hits, Last modified:
ULCO 44/66/88/132 - Belt driven linear units @ulco
2 Hits, Last modified:
ULCO 66 @ulco
2 Hits, Last modified:
ULCO 132 @ulco
2 Hits, Last modified:
ULCO 44 @ulco
2 Hits, Last modified:
ULCO 88 @ulco
2 Hits, Last modified:
ULCV 66 @ulco
2 Hits, Last modified:
ULCV 132 @ulco
2 Hits, Last modified:
Glossary
1 Hits, Last modified:
Protection
1 Hits, Last modified:
Inputs and outputs connection @epulse50_dc_servodrive
1 Hits, Last modified:
MODBUS RTU @epulse50_dc_servodrive
1 Hits, Last modified:
Register mapping @epulse50_dc_servodrive
1 Hits, Last modified:
Connection system @gdm_linear_axes
1 Hits, Last modified:
Encoder type @gdm_linear_axes
1 Hits, Last modified:
GDM Tubular Linear Stage @gdm_linear_axes
1 Hits, Last modified:
IP protection and Cooling @green_drive_iso
1 Hits, Last modified:
Maintenance of antirotation mechanics @green_drive_motors
1 Hits, Last modified:
Connection system @green_drive_motors
1 Hits, Last modified:
IP protection and Cooling @green_drive_motors
1 Hits, Last modified:
Green Drive in Parallel drive @green_drive_motors
1 Hits, Last modified:
EtherCAT to MODBUS RTU Gateway @gtw_ethercat
1 Hits, Last modified:
Position table @gtw_ethercat
1 Hits, Last modified:
Can OPEN Error Codes @integrated_drive_motors
1 Hits, Last modified:
Can Open Mode of Operation @integrated_drive_motors
1 Hits, Last modified:
MODBUS RTU Interface @integrated_drive_motors
1 Hits, Last modified:
Connectors @integrated_rotolinear
1 Hits, Last modified:
Identification of the motor components @ironcore_motors
1 Hits, Last modified:
Liquid Cooled Motors (LK) @ironcore_motors
1 Hits, Last modified:
L/LK Ironcore linear motors @ironcore_motors
1 Hits, Last modified:
CanOPEN PDO Example @mbd_servo_drive
1 Hits, Last modified:
Installation @mbd_servo_drive
1 Hits, Last modified:
MBM Motors connections @mbd_servo_drive
1 Hits, Last modified:
MODBUS RTU @mbd_servo_drive
1 Hits, Last modified:
Register mapping @mbd_servo_drive
1 Hits, Last modified:
Safety @mbd_servo_drive
1 Hits, Last modified:
MBD 230/400 Servo Drive @mbd_servo_drive
1 Hits, Last modified:
Adapter cable @miniature_motors
1 Hits, Last modified:
SIN/COS Encoder converter - Interpolator @miniature_motors
1 Hits, Last modified:
Interface description @nilab_starter
1 Hits, Last modified:
MODBUS Trigger Configuration @nilab_starter
1 Hits, Last modified:
Motion controller @nilab_starter
1 Hits, Last modified:
Starter interface windows @nilab_starter
1 Hits, Last modified:
How to save and reload the configuration @nilab_starter
1 Hits, Last modified:
Encoder @nl_bcj_linear_stage
1 Hits, Last modified:
Motor Cables @nl7_servo
1 Hits, Last modified:
Pacdrive 3 - Schneider Electric @reverso_encoder
1 Hits, Last modified:
Technical Data @reverso_encoder
1 Hits, Last modified: